The 90.4 Competition series amplifer is a 90 watts per channel @ 4 ohms or 130 watts per channel @ 2 ohms. This amp has a fully active crossover and lots of clean power for the SQ minded builds. Its also fits installs where you may want to amplify your front stage and bridge the rear 2 channels to your sub stage and have a bass knob to control it. Versatility is what this amp is all about.
|
Features |
Voltage |
90.4 |
Output Power (RMS) |
4 ohm |
|
90Wx4 |
|
2 ohm |
14.4V |
130Wx4 |
|
1 ohm |
|
n/a |
|
4 ohm mono |
14.4V |
250Wx2 |
|
1 ohm |
18V |
n/a |
Input Sensitivity |
6V~0.2V |
Frequency Response |
|
Hz |
20Hz~20KHz |
12dB / Octave Crossover |
|
CH1/2 |
Subsonic Filter |
10Hz ~ 100Hz |
Crossover |
50Hz(500Hz) ~ 5ooHz(5KHZ ) |
Multiply |
x1, x10 |
Crossover Selector Switch |
HPF / FULL / LP-BP |
Bass Boost |
0~18dB |
CH3/4 |
Subsonic Filter |
10Hz ~ 100Hz |
Crossover |
50Hz(500Hz) ~ 5ooHz(5KHZ ) |
Multiply |
x1, x10 |
Crossover Selector Switch |
HPF / FULL / LP-BP |
Bass Boost |
0~18dB |
Remote Control |
Frequency Response |
|
Hz |
20-20Khs |
Signal to Noise Ratio |
|
dB |
105 |
Damping Factor |
|
200< |
THD @ 4ohms |
|
Less than 0.1% |
Fuse Rating |
On Board |
Yes |
80 Amps |
Indicator |
Power |
Yes |
|
Protection |
Yes |
Speaker & Power terminal |
Mold Type |
|
Yes |
|
Power |
Gauge |
4Ga |
Heatsink Length |
inch/mm |
|
14.00"/350mm |
Heatsink Width |
inch/mm |
|
9.38"/66mm |
Heatsink Height |
inch/mm |
|
2.35"/59.6mm |