The Star Power 10000 amplifier is a single channel Mono amplifier designed to run at a 1 ohm load and is rated to produce 11000 Watts or more at 14.4V.
Star Power amplifiers are designed to offer better than rated power output capabilities along with the maximum possible reliability. These amplifiers will meet or beat their rated specifications
Star Power 10000 amplifiers can be linked together (strapped) so that 2 amplifiers can be combined to run as a single amplifier, or they can be run in LINKED mode as separate amplifiers but controlled by a single remote and settings from the master amplifier.
Standard version features include:
1/0 Power and Ground terminal blocks (QUAD 1/0 for Star Power 10000)
Tiffany style RCA connections
Remote gain control knob
Clipping indicator (located on the amplifier and the remote gain control)
Protection indicator (located on the amplifier)
Thermal/Over Current/Speaker Short/Speaker DC protection circuits
Pink colored Double-sided epoxy PCB
Pink power LEDs
Custom tooled star heatsink
Reversible logo panel
Technical Specifications for Star Power 10000 Amplifier:
RMS Power Output @ 14.4V
4 ohms mono = 4000 Watts
2 ohms mono = 7000 Watts
1 ohm mono = 11000Watts
4 ohms linked (2 amplifiers) = 12500 Watts
2 ohms linked (2 amplifiers) = 22000 Watts
Signal-to-noise ratio = >90 db
Low pass frequency crossover = 30 Hz~250 Hz
Subsonic filter = 10 Hz~70 Hz
Bass boost = 0~12 db
Bass boost frequency = 30 Hz~90 Hz
Phase shift control = 0~180°
Frequency response = 10 Hz~350 Hz
THD @ 4 ohm, 100 Hz = <0.1%
Efficiency @ 4 ohm, 100 HZ = 90%
Damping factor = >350
Input sensitivity = Variable 8V~200mV
Operating voltage = 8.5V~16V DC
Recommended inline fuse size = 1000A
We recommend using a minimum of 10 AWG speaker cable, 8 AWG is preferred.
Do not mount your amplifier to your enclosure. Excess vibrations will cause damage.
Use fuses between the battery and amplifier (recommended 18″ or less from the battery) at 1000 amps for the Star Power 10000.
We recommend a minimum starting impedance of 0.7 ohms (1 ohm rated load) for maximum reliability
Physical Specifications for Star Power 5000 Amplifier:
Width 10.89″ / 276 mm
Length 33.7″ / 855 mm
Height 3.1” / 78.5 mm
Products manufactured by PSI Car Audio are covered by a 1 year warranty.
For further warranty information please see below url.